Mixing and Diverting Valves

359-0X4000-XXX

DOWNLOAD REQUEST QUOTE
The Thermostatic Mixing/Diverting Valve is designed to maintain or proportion flow based on temperature in mixing or diverting applications. In mixing applications where a controlled temperature outlet is required, the thermal mixing valve (M/D) will modulate between the hot and cold inlet feeds (ports “B” and “C”) to mix your fluid to the desired specified temperature exiting the “A” port. In diverting applications where the fluid must be directed from one section of a system to another, the thermal diverting valve (aka thermal bypass valve) will modulate inlet fluid temperature and divert return flow through a cooler/ heat exchanger or bypass it to a reservoir/ bypass loop when fluid temperatures are satisfied. This action assures rapid system warm-up, accurate control of fluid temperature, and reduced back pressure in the return.
Aviation Radar Cooling Fuel/Oil Cooler
Battery Cooling Hydraulic thermal bypass
Cooling water control for radiator or heat exchanger Loop-type circulation systems
Direct cooling with raw water Lube oil cooling control
Direct injection water heating Lube oil thermal bypass
Electronics system cooling Temperature control for baths, wash basins, and sinks
Engine and compressor cooling system Temperature mixing or diverting
Hydraulic fluid cooling systems Thermal Management
Hydraulic power units (HPUs) Water saving applicationsl
  • Exclusive self-actuating Thermoloid® wax blend thermal actuator
  • Heavy-duty – rugged construction
  • Compact and low mass for fast response
  • Operates in narrow temperature band
  • Standard valve material is bronze or stainless steel
  • Self-operating – no external power source required
  • Minimal maintenance needed
  • Wide temperature range
  • Easy installation
  • Few moving parts – Reduce system wear
Series Mixing and Diverting Valves
Description 2" M/D Valve - SS
Size 2" NPT
Width-in 6
Width-mm 152
Height-in 6.8
Height-mm 173
Weight lb 11
Weight kg 5
Cv 18
Maximum Operating Pressure 250 PSIG (17.2 BAR)
Maximum Temperature 250°F (121°C)
Opening Temperature 35°F, 45°F, 50°F, 60°F, 70°F(+/- 8°F), 85°F, 90°F, 100°F, 105°F, 110°F, 125°F, 130°F(+/- 8°F), 135°F, 147°F (+/- 8°F), 152°F (+/- 8°F), 160°F, 170°F, 190°F, 200°F, 205°F, 210°F (1.7°C, 7.2°C, 10°C, 15.6°C, 21.1°C, 29.4°C, 32.2°C, 37.8°C, 40.6°C, 43.3°C, 51.7°C, 54.4°C, 57.2°C, 63.9°C, 66.7°C, 71.1°C, 76.7°C, 87.8°C, 93.3°C, 96.1°C, 98.9°C)
Closing Temperature Unless otherwise noted, during operation, the valve will modulate the Cold side (C port) closed at 5°F below the set-point, and the Hot side (B port) closed at 5°F above the set-point.
Body Material 316 Stainless Steel
ANSI Body Compliance 150 Class
Seal Material Available in Buna-N, EPDM, Viton, or Fluorosilicone
Isometric View Download
Front View Download
Top View Download
Side View Download

Write a review

Note: HTML is not translated!
    Bad           Good